Mazda 3 manuals

Mazda 3 Service Manual: Front Fog Light Relay Removal/Installation

Mazda 3 Service Manual / Electrical / Fuses & Junction Blocks / Front Fog Light Relay Removal/Installation

1. Disconnect the negative battery cable..

2. Remove the front mudguard.(RH).

3. Remove the front fog light relay case.


4. Remove the cover.

5. Remove the front fog light relay.

6. Install in the reverse order of removal..

Front Fog Light Relay Installation Note

1. Install the front fog light relay case to the shroud panel with the front fog light relay cover facing upward.

CAUTION:


Fuses & Junction Blocks
...

Main Fuse Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove nuts A and B shown in the figure. 3. Remove the main fuse. 4. Install in the reverse order of removal. ...

Other materials:

Climate Control Unit Inspection [Manual Air Conditioner]
1. Remove the climate control unit with the connector connected.. 2. Switch the ignition to ON. 3. Connect the negative (-) lead of the tester to the body ground. 4. By inserting the positive (+) lead of the tester into the climate control unit connector, measure the voltage according to the ...

ABS HU/CM Inspection
1. Disconnect the ABS HU/CM connector.. 2. Connect the negative battery cable.. 3. Attach the tester lead to the ABS HU/CM wiring harness-side connector and inspect the voltage, continuity, or resistance according to the standard (reference value) in the table below. Standard (reference) ...

Recommended Oil
U.S.A., Canada, and Puerto Rico Use SAE 0W-20 engine oil. Mazda Genuine Oil is used in your Mazda vehicle. Mazda Genuine 0W-20 Oil is required to achieve optimum fuel economy. For maintenance service, Mazda recommends Mazda Genuine Parts and Castrol ® (U.S.A. only). Only use SAE 0W ...

� 2016-2026 Copyright www.mazda3tech.com