Mazda 3 manuals

Mazda 3 Service Manual: Fuel Filter (High Pressure) Removal/Installation [Mzr 2.0, Mzr 2.5]

Mazda 3 Service Manual / Engine / Fuel / Fuel Filter (High Pressure) Removal/Installation [Mzr 2.0, Mzr 2.5]

WARNING:

1. Complete the “BEFORE SERVICE PRECAUTION”..

2. Remove the battery cover..

3. Disconnect the negative battery cable..

4. Remove the rear seat cushion..

5. Remove the fuel pump unit..

6. Remove the fuel filter (high-pressure)..

7. Install in the reverse order of removal.

8. Complete the “AFTER SERVICE PRECAUTION”..

Fuel Filler Lid Removal/Installation
1. Remove the bolts. 2. Remove the fuel-filler lid. 3. Install in the reverse order of removal. 4. Adjust the fuel-filler lid.. ...

Fuel Injector Inspection [Mzr 2.0, Mzr 2.5]
Resistance Inspection 1. Remove the battery cover.. 2. Disconnect the negative battery cable.. 3. Disconnect the fuel injector connector. 4. Inspect the resistance between fuel injector termina ...

Other materials:

DSC Sensor Initialization Procedure
WARNING: If the DSC sensor initialization procedure is not completed, the DSC will not operate properly and it might cause an unexpected accident. Therefore, after replacing or removing the DSC HU/CM or SAS control module, make sure to perform the DSC sensor initialization procedure ...

Antenna Amplifier Removal/Installation
With Audio Unit (Without Display) 1. Disconnect the negative battery cable.. 2. Remove the rain sensor cover. (Vehicles with auto light/wiper system). 3. Disconnect the rain sensor connector. (Vehicles with auto light/wiper system) 4. Partially peel back the seaming welts. 5. Remove the fo ...

Antenna (5-Door)
AM/FM Radio Antenna * The AM/FM radio antenna receives both AM and FM signals. (Type A) To remove the antenna, turn it counterclockwise. To install the antenna, turn it clockwise. Make sure the antenna is securely installed. CAUTION To prevent damage to the antenna, r ...

� 2016-2026 Copyright www.mazda3tech.com