Mazda 3 manuals

Mazda 3 Service Manual: Plug Hole Plate Removal/Installation [Mzr 2.0, Mzr 2.5]

Mazda 3 Service Manual / Engine / General / Plug Hole Plate Removal/Installation [Mzr 2.0, Mzr 2.5]

1. Remove the plug hole plate in the order indicated in the figure.

NOTE:


2. Install the plug hole plate in the reverse order of removal.

Non Return Valve Inspection [Skyactiv G 2.0]
WARNING: Fuel is very flammable liquid. If fuel spills or leaks from the pressurized fuel system, it will cause serious injury or death and facility breakage. Fuel can also irritate skin ...

Variable Swirl Shutter Valve Actuator Inspection [Mzr 2.3 Disi Turbo]
Operation Inspection 1. Remove the air hose.. 2. Disconnect the vacuum hose from the variable swirl control solenoid valve. 3. Connect a vacuum pump to the variable swirl shutter valve actuator. ...

Other materials:

Washer Motor Inspection
1. Disconnect the negative battery cable.. 2. Remove the front mudguard (RH).. 3. Disconnect the washer motor connector. 4. After connecting washer motor terminal A to the positive battery terminal, and terminal B to the negative battery terminal, verify that washer fluid flows to the wind ...

Front Seat Belt Removal/Installation [Two Step Deployment Control System]
WARNING: Handling the front seat belt (pre-tensioner seat belt) improperly can accidentally deploy the pre-tensioner seat belt, which may seriously injure you. Read the air bag system service warnings and cautions before handling the front seat belt.. WARNING: Th ...

Engine Coolant Replacement [Mzr 2.0, Mzr 2.5]
WARNING: Never remove the cooling system cap or loosen the radiator drain plug while the engine is running, or when the engine and radiator are hot. Scalding engine coolant and steam may shoot out and cause serious injury. It may also damage the engine and cooling system. Tu ...

� 2016-2026 Copyright www.mazda3tech.com