Mazda 3 Service Manual: Power Metal Oxide Semiconductor Field Effect Transistor (Power Mos Fet) Inspection [Full Auto Air Conditioner]
1. Verify that the continuity between the power MOS FET terminals is as indicated in the table.
-
If there is any malfunction, replace the power MOS FET.
-
If the blower motor operation is not normal even though no malfunction can be verified, inspect the climate control unit..
|
Tester lead |
Resistance (kilohm) |
|
|
+ |
- |
|
|
A |
B |
∞ |
|
A |
C |
6.9 |
|
B |
A |
Continuity detected |
|
B |
C |
Continuity detected |
|
C |
A |
6.9 |
|
C |
B |
∞ |
Passenger Compartment Temperature Sensor Removal/Installation [Full Auto Air
Conditioner]
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Front scuff plate.
b. Front side trim.
c. Dashboard under cover.
d. Upper panel.
e. Shift lever knob (MTX).
f ...
Power Metal Oxide Semiconductor Field Effect Transistor (Power Mos Fet) Removal/Installation
[Full Auto Air Conditioner]
1. Disconnect the negative battery cable..
2. Remove the dashboard under cover..
3. Disconnect the connector.
4. Remove the screw.
5. Remove the power MOS FET.
6. Install in the reverse ...
Other materials:
Spark Plug Removal/Installation [Mzr 2.3 Disi Turbo]
CAUTION:
If a spark plug that is not as specified is installed, engine performance
will be deteriorated. Install only the specified spark plug when replacing.
1. Remove the battery cover..
2. Disconnect the negative battery cable..
3. Remove the charge air cooler..
4. Remove t ...
Rear ABS Wheel Speed Sensor Inspection
Installation Visual Inspection
1. Inspect for the following:
If there is any malfunction, replace the part.
a. Excessive looseness or play of the rear ABS wheel-speed sensor
b. Deformation of the rear ABS wheel-speed sensor
c. Deformation or damage of the rear ABS sensor rotor
C ...
Transaxle Range (TR) Switch Inspection [FS5 A EL]
CAUTION:
Water or foreign objects entering the connector can cause a poor connection
or corrosion. Be sure not to drop water or foreign objects on the connector
when disconnecting it.
Operation Inspection
1. Perform the following procedures to inspect the TR switch.
If t ...
