Mazda 3 manuals

Mazda 3 Service Manual: HVAC

Oil Pressure Switch Removal/Installation [FS5 A EL]
WARNING: A hot transaxle and ATF can cause severe burns. Turn off the engine and wait until they are cool. 1. Perform the following procedures. a. Remove the battery cover.. b. Di ...

General
...

Other materials:

Rear Bumper Removal/Installation
4SD 1. Disconnect the negative battery cable.. 2. Remove the rear combination light.. 3. Remove the fastener A and screw B. 4. Remove the rear splash shield.. 5. Remove the screws C. 6. Remove the bolts D. 7. Affix the protective tape to the position shown in the figure. ...

Power Outer Mirror Switch Inspection
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Inner garnish. b. Front door trim. c. Switch panel. 3. Verify that the continuity between the power outer mirror switch terminals is as indicated in the table. If not as indicated in the table, replace t ...

Windshield Defrosting and Defogging
Set the mode selector dial to the position. Set the temperature control dial to the desired position. Set the fan control dial to the desired speed. If dehumidified heating is desired, turn on the air conditioner. WARNING Do not defog the windshield using the pos ...

� 2016-2026 Copyright www.mazda3tech.com