Mazda 3 Service Manual: Drive Belt Inspection [Skyactiv G 2.0]
Generator Drive Belt
NOTE:
-
The generator drive belt deflection/tension inspection is not necessary with the adoption of the drive belt auto tensioner.
1. Verify that the indicator part of the cast hexagon on the drive belt auto tensioner is within the normal range.
-
If it exceeds the limit, replace the drive belt..
Water Pump Drive Belt
NOTE:
-
The water pump drive belt deflection/tension inspection is not necessary with the adoption of the stretch-type water pump drive belt.
1. Visually inspect or feel that there is no wear, damage, or cracking on the inside and sides of the entire the belt.
-
Even if there is a little wear, damage, or cracking, replace the water pump drive belt..
2. Start the engine to verify that abnormal noise does not occur.
-
If abnormal noise occurs, replace the water pump drive belt..
Drive Belt Inspection [Mzr 2.3 Disi Turbo]
NOTE:
Drive belt deflection/tension inspection is not necessary because of the
use of the drive belt auto tensioner.
1. Verify that the drive belt auto tensioner indicator mark does n ...
Drive Belt Removal/Installation [Mzr 2.0, Mzr 2.5]
MZR 2.0
A/C drive belt removal
1. Remove the aerodynamic under cover No.2 and splash shield as a single unit..
2. Remove the nut shown in the figure and set the power steering pipe component
ou ...
Other materials:
Windshield Defrosting and
Defogging
Set the mode selector dial to the
position and turn the fan control dial to the
desired speed.
In this position, the outside air position is automatically selected, and when
the fan control dial is ON, the air conditioner automatically turns on. The air
conditioner will directly dehumidify ...
Stay Damper Disposal
NOTE:
The stay damper contains colorless, odorless, nontoxic gas.
1. Wear protective eye wear.
2. Position the stay damper horizontally.
3. Drain gas and oil by cutting the position indicated in the figure to a
2—3 mm {0.08—0.11 in} depth using a metal saw.
CAUTION:
...
Hood Latch And Release Lever Removal/Installation
Hood latch
1. Open the hood.
2. Disconnect the negative battery cable..
3. Disconnect the hood latch switch connector. (vehicles with theft-deterrent
system)
4. Remove the bolts.
5. Remove the hood latch.
6. Install in the reverse order of removal.
7. Adjust the hood..
Hood ...
