Mazda 3 manuals

Mazda 3 Service Manual: Condenser Inspection

Mazda 3 Service Manual / HVAC / A/C / Condenser Inspection

1. Inspect the condenser for cracks, damage, and oil leakage.

2. Visually inspect the fins for clogging of foreign material.

3. Visually inspect for bent fins.

Climate Control Unit Removal/Installation [Manual Air Conditioner]
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Upper panel. b. Shift lever knob (MTX). c. Selector lever knob (ATX). d. Shift panel. e. Side wall. f. Consol ...

Condenser Removal/Installation
1. Disconnect the negative battery cable.. 2. Discharge the refrigerant.. 3. Drain the engine coolant.. 4. Remove the air cleaner.. 5. Remove the aerodynamic under cover No.2.. 6. Remove the ...

Other materials:

Oil Control Valve (OCV) Inspection [Mzr 2.0, Mzr 2.5]
Coil Resistance Inspection 1. Remove the battery cover.. 2. Disconnect the negative battery cable.. 3. Remove the plug hole plate.. 4. Disconnect the OCV connector. 5. Measure the resistance between terminals A and B using an ohmmeter. OCV coil resistance 6.9—7.9 ohms [20°C ...

Rear Tilt Motor Inspection
1. Remove the battery cover.. 2. Disconnect the negative battery cable and wait 1 min or more.. 3. Disconnect the rear tilt motor connector. 4. Apply battery positive voltage to the rear tilt motor terminals and inspect the rear tilt motor operation If not as specified, replace t ...

Maintenance of the Active Driving Display
The combiner and mirror surface have a special coating. When cleaning, do not use a hard or rough-surface cloth, or cleaning detergent. In addition, if a chemical solvent gets on the active driving display, wipe it off immediately. Otherwise, the combiner and mirror could be damaged and the s ...

� 2016-2026 Copyright www.mazda3tech.com