Mazda 3 manuals

Mazda 3 Service Manual: Ambient Temperature Sensor Inspection [Full Auto Air Conditioner]

Mazda 3 Service Manual / HVAC / A/C / Ambient Temperature Sensor Inspection [Full Auto Air Conditioner]

1. Measure the temperature around the ambient temperature sensor and measure the resistance between the ambient temperature sensor terminal.


Airflow Mode Actuator Removal/Installation [Full Auto Air Conditioner]
1. Set the air intake mode to FRESH. 2. Set the air mix mode to MAX COLD. 3. Disconnect the negative battery cable.. 4. Remove the following parts: a. Front doors. b. Front scuff plate. c. ...

Ambient Temperature Sensor Inspection [Manual Air Conditioner]
1. Measure the temperature around the ambient temperature sensor and measure the resistance between the ambient temperature sensor terminal. If the characteristics of the ambient tempera ...

Other materials:

Clutch Pedal Position (CPP) Switch Inspection [Mzr 2.0, Mzr 2.5]
Continuity Inspection 1. Verify that the CPP switch is installed properly.. 2. Remove the battery cover.. 3. Disconnect the negative battery cable.. 4. Disconnect the CPP switch connector.. 5. Verify that the continuity between CPP switch terminals A and B when the clutch pedal is depress ...

Driver Side Air Bag Module Removal/Installation [Standard Deployment Control System]
WARNING: Handling the air bag module improperly can accidentally deploy the air bag module, which may seriously injure you. Read the air bag system service warnings and cautions before handling the air bag module.. 1. Switch the ignition to off. 2. Disconnect the negative batte ...

Wheel Hub, Steering Knuckle Inspection
Wheel Bearing Excessive Play Inspection 1. Install the magnetic base and dial gauge as shown in the figure and measure the wheel bearing axial excessive play. If it exceeds the maximum specification, replace the wheel hub bearing. Maximum front wheel bearing play 0.05 mm ...

� 2016-2026 Copyright www.mazda3tech.com