Mazda 3 Service Manual: Sensors, Switches, Relays

Evaporator Temperature Sensor Inspection [Manual Air Conditioner]

NOTE: Inspect the evaporator temperature sensor when it is installed to the A/C unit. 1. Set the fan speed MAX HI. 2. Set the temperature control at MAX COLD. 3. Set the RECIRCULA ...

Ambient Temperature Sensor Inspection [Full Auto Air Conditioner]

1. Measure the temperature around the ambient temperature sensor and measure the resistance between the ambient temperature sensor terminal. If the characteristics of the ambient tempera ...

Other materials:

Magnetic Clutch Adjustment [Manual Air Conditioner]
1. Measure the clearance around the entire circumference between the pressure plate and A/C compressor pulley using a thickness gauge. 2. Verify that the clearance. If not within the specification, remove the pressure plate and adjust the clearance by changing the shim (0.2 mm {0. ...

Bass Box Inspection
1. Disconnect the negative battery cable.. 2. Disconnect the connector.. 3. Verify the resistance between bass-box terminals. If not within the specification, replace the bass-box. Resistance 0.9—1.1 ohms ...

Water Pump Removal/Installation [Mzr 2.0, Mzr 2.5]
WARNING: Never remove the cooling system cap or loosen the radiator drain plug while the engine is running, or when the engine and radiator are hot. Scalding engine coolant and steam may shoot out and cause serious injury. It may also damage the engine and cooling system. Tu ...