Mazda 3 manuals

Mazda 3 Service Manual: Rear Washer Nozzle Adjustment

Mazda 3 Service Manual / Body / Wipers, Washers / Washers / Rear Washer Nozzle Adjustment

1. Insert a needle or an equivalent tool into the spray hole of the rear washer nozzle and adjust the nozzle direction as shown.


Rear Washer Hose Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the front mudguard (RH).. 3. Disconnect rear washer hose A from the washer motor. 4. Remove the rear washer hose A from clip A, B, C, D, ...

Rear Washer Nozzle Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Liftgate upper trim. b. Rear spoiler. c. High-mount brake light. 3. Disconnect the rear washer hose. 4. Press t ...

Other materials:

Torque Converter Clutch (TCC) Non Operation [Fw6 A EL]
TROUBLESHOOTING ITEM Torque converter clutch (TCC) non-operation DESCRIPTION TCC does not operate when vehicle reaches TCC operation range. POSSIBLE CAUSE Signal malfunction ...

Wheel Unit ID Registration
NOTE: After the wheel unit replacement, registration of the wheel unit identification codes must be performed. ID registration can be done using the M-MDS, or not using the M-MDS. Using M-MDS 1. Connect the M-MDS to DLC-2. 2. After the vehicle is identified, select th ...

Body Control Module (Bcm) Inspection
1. Remove the following parts: a. Front scuff plate (LH). b. Front side trim (LH). c. Upper panel. d. Shift knob (MTX). e. Selector lever knob (ATX). f. Shift panel. g. Side wall. h. Console. 2. Set the hood release lever out of the way.. 3. Remove the lower panel. (driver-side). ...

� 2016-2026 Copyright www.mazda3tech.com