Mazda 3 manuals

Mazda 3 Service Manual: Washers

Wiper And Washer Switch Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the column cover. 3. Disconnect the wiper and washer switch connector. 4. Remove the screws. 5. Remove the wiper and washer switch. 6 ...

Rear Washer Hose Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the front mudguard (RH).. 3. Disconnect rear washer hose A from the washer motor. 4. Remove the rear washer hose A from clip A, B, C, D, ...

Other materials:

Starter Cut Relay Removal/Installation [MTX]
Advanced Keyless Entry And Push Button Start System Only 1. Disconnect the negative battery cable.. 2. Remove the following parts: Front scuff plate (LH). Front side trim (LH). Side wall. Console. 3. Set the hood release lever out of the way.. 4. Remove the ...

Oil Seal (Differential) Replacement [C66 M R]
1. Remove the aerodynamic under cover No.2 and the splash shield as a single unit.. 2. Drain the manual transaxle oil.. 3. Disconnect the drive shaft (LH) from the MTX.. 4. Disconnect the drive shaft (RH) from the joint shaft.. 5. Remove the joint shaft.. 6. Remove the oil seal (LH). ...

Passenger Compartment Temperature Sensor Inspection [Full Auto Air Conditioner]
1. Measure the temperature around the passenger compartment temperature sensor and measure the resistance between passenger compartment temperature sensor terminals B and D. If the characteristics of the passenger compartment temperature sensor are not as shown in the graph, repla ...

� 2016-2026 Copyright www.mazda3tech.com