Mazda 3 Service Manual: Restraints SST [Two Step Deployment Control System]

Restraints SST [Standard Deployment Control System]

49 H066 002 Deployment tool 49 D066 002 Adapter harness 49 L066 002 Adapter harness ...

Adjuster Anchor Removal/Installation

WARNING: The side air bag sensor is attached to the lower part of the B-pillar. When working around the B-pillar, disconnect the negative battery cable or work carefully, avoiding exce ...

Other materials:

Front Door Latch Switch Inspection
1. To access the glass installation bolt, position the front door glass so that the distance from the top of the front door glass to the upper part of the front beltline molding is approx. 80 mm {3.1 in}. 2. Disconnect the negative battery cable.. 3. Remove the following parts: a. Inne ...

Fuel Filler Lid Opener Cable Removal/Installation
4SD 1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Front seat (LH). b. Front scuff plate (LH). c. Rear scuff plate. d. B-pillar lower trim. e. Rear seat cushion. f. Rear seat back. g. Tire house trim. h. Trunk end trim. i. Trunk side trim (RH). j. ...

Replacing Windshield Wiper Blades
When the wipers no longer clean well, the blades are probably worn or cracked. Replace them. CAUTION To prevent damage to the wiper arms and other components, do not try to sweep the wiper arm by hand. NOTE When raising both windshield wiper arms, raise the driver's side ...