Mazda 3 manuals

Mazda 3 Service Manual: Trailer

Passenger Air Bag Deactivation (Pad) Indicator Light Bulb Removal/Installation [Two Step Deployment Control System]
NOTE: The PAD indicator light (LED) is built into the multi information display/information display. 1. Remove the information display. (With information display). 2. Remove the mul ...

Towing
Proper lifting and towing are necessary to prevent damage to the vehicle. Government and local laws must be followed. A towed vehicle usually should have its drive wheel (front wheels ...

Other materials:

Temporary Spare Tire
Inspect the temporary spare tire at least monthly to make sure it is properly inflated and stored. NOTE The temporary spare tire condition gradually deteriorates even if it has not been used. The temporary spare tire is easier to handle because of its construction which is lighter and small ...

Wheel Hub Component Removal/Installation
CAUTION: Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the wiring harness if it is pulled by mistake. Before performing the following procedures, disconnect the ABS wheel-speed sensor connector (axle side) ...

Vehicle Speed Sensor (VSS) Inspection [FS5 A EL]
On-Vehicle Inspection 1. Inspect the power supply circuit for the VSS. a. Remove the insulator from the transaxle. b. Disconnect the VSS connector. c. Switch the ignition to ON (engine off). d. Measure the voltage at VSS connector terminal A (harness-side). If there is a ...

� 2016-2026 Copyright www.mazda3tech.com