Mazda 3 manuals

Mazda 3 Service Manual: Inspection After Manual Transaxle Overhaul [C66 M R]

Mazda 3 Service Manual / Drivetrain / Transmission/Transaxle / Manual transmission / Inspection After Manual Transaxle Overhaul [C66 M R]

1. After warming up the engine, drive the vehicle and inspect the following items:

a. No abnormal noise in each shift position.

b. Smooth shift operation when shifting gears.

c. No gear slipout after shifting gears.

d. Back-up light switch operates correctly.

Manual transmission
...

Manual Transaxle Oil Inspection [C66 M R]
1. Park the vehicle on level ground. 2. Remove the aerodynamic under cover No.2.. 3. Remove the oil level plug and gasket. Tightening torque 39—59 N·m {4.0—6.0 kgf·m, 29—43 f ...

Other materials:

Fuel Filter (High Pressure) Removal/Installation [Mzr 2.0, Mzr 2.5]
WARNING: Fuel is very flammable liquid. If fuel spills or leaks from the pressurized fuel system, it will cause serious injury or death and facility breakage. Fuel can also irritate skin and eyes. To prevent this, always complete the “Fuel Line Safety Procedure”, while referring ...

DSC Sensor Initialization Procedure
WARNING: If the DSC sensor initialization procedure is not completed, the DSC will not operate properly and it might cause an unexpected accident. Therefore, after replacing or removing the DSC HU/CM or SAS control module, make sure to perform the DSC sensor initialization procedure ...

Magnetic Clutch Adjustment [Manual Air Conditioner]
1. Measure the clearance around the entire circumference between the pressure plate and A/C compressor pulley using a thickness gauge. 2. Verify that the clearance. If not within the specification, remove the pressure plate and adjust the clearance by changing the shim (0.2 mm {0. ...

� 2016-2026 Copyright www.mazda3tech.com