Mazda 3 manuals

Mazda 3 Owners Manual: Instrument Cluster and Display

Mazda 3 Owners Manual / When Driving / Instrument Cluster and Display

Turning the Engine Off
WARNING Do not stop the engine while the vehicle is moving: Stopping the engine while the vehicle is moving for any reason other than in an emergency is dangerous. Stopping th ...

Meters and Gauges
Speedometer Odometer, Trip Meter and Trip Meter Selector Tachometer Fuel Gauge Dashboard Illumination. Outside Temperature Display . Cruise Control Set Vehicle Speed Display Acti ...

Other materials:

Antenna Feeder No.5 Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Front scuff plate (RH). b. Front side trim (RH). c. Rear scuff plate (RH). d. B-pillar lower trim (RH). e. Rear seat cushion. f. Tire house trim (RH). 3. Partially peel back the floor covering. 4. Disconne ...

Manifold Absolute Pressure (Map) Sensor/Intake Air Temperature (Iat) Sensor No.2 Removal/Installation [Skyactiv G 2.0]
NOTE: Because the IAT sensor No.2 is integrated in the MAP sensor, replacing the IAT sensor No.2 includes replacement of the MAP sensor/IAT sensor No.2. 1. Remove the battery cover.. 2. Disconnect the negative battery cable.. 3. Disconnect the MAP sensor/IAT sensor No.2 connecto ...

Wastegate Actuator Inspection [Mzr 2.3 Disi Turbo]
1. Remove the air hose and air duct.. 2. Disconnect the hose from the wastegate actuator. 3. Plug the wastegate actuator as shown in the figure. 4. Connect the vacuum pump to the port 5. Raise the pressure slowly and take a measurement of the pressure when the rod stroke is 1.5 mm {0.0 ...

� 2016-2026 Copyright www.mazda3tech.com