Mazda 3 manuals

Mazda 3 Service Manual: Base Removal

Mazda 3 Service Manual / Body / Mirrors / Base Removal

1. Remove the rearview mirror..

2. Wind each end of a wire around a bar.


WARNING:

NOTE:

3. Fix one end of the piano wire, and while pulling the other end, cut the sealant to remove the base.

Base Installation
1. Cut away all of the original sealant using a razor. WARNING: Using a razor with bare hands can cause injury. Always wear gloves when using a razor. 2. Clean and degrease the cera ...

Filament Inspection
1. Turn the ignition switch to the ON position. 2. Turn the rear window defroster switch on. CAUTION: Directly touching the rear window defroster filament with the lead of the teste ...

Other materials:

PID/Data Monitor Inspection [Two Step Deployment Control System]
1. Connect the M-MDS (IDS) to the DLC-2. 2. After the vehicle is identified, select the following items from the initialization screen of the IDS. a. Select “DataLogger”. b. Select “Modules”. c. Select “RCM”. 3. Select the applicable PID from the PID table. 4. Verify th ...

Passenger Compartment Temperature Sensor Removal/Installation [Full Auto Air Conditioner]
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Front scuff plate. b. Front side trim. c. Dashboard under cover. d. Upper panel. e. Shift lever knob (MTX). f. Selector lever knob (ATX). g. Shift panel. h. Side wall. i. Console. j. Hood release lever ...

Cargo Compartment Light Inspection
1. Disconnect the negative battery cable.. 2. Remove the cargo compartment light.. 3. Verify that the continuity between the cargo compartment light terminals is as indicated in the table. If not as indicated in the table, inspect the bulb. If there is no malfunction, replace th ...

� 2016-2026 Copyright www.mazda3tech.com