Mazda 3 manuals

Mazda 3 Service Manual: Mirrors

Vanity Mirror Illumination Bulb Removal/Installation
1. Disconnect the negative battery cable.. 2. Insert a tape-wrapped fastener remover into the service hole, and pry it in the direction indicated by the arrow to remove the lens. 3. Remove t ...

Auto Dimming Mirror Inspection
1. Measure the voltage at each terminal. If the voltage is not as specified in the Terminal Voltage Table (Reference), inspect the parts under “Inspection item (s)” and related wiring h ...

Other materials:

Rear Combination Light Removal/Installation
4SD 1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Trunk mat. b. Trunk board. c. Trunk end trim. d. Trunk side trim. 3. Disconnect the connectors shown in the figure and remove the nuts. 4. Pull the rear combination light in the direction of the arrow ...

Input/Turbine Speed Sensor Inspection [FS5 A EL]
CAUTION: Water or foreign objects entering the connector can cause a poor connection or corrosion. Be sure not to drop water or foreign objects on the connector when disconnecting it. On-Vehicle Inspection 1. Perform the following procedures. a. Remove the battery cover.. b. ...

Rear ABS Wheel Speed Sensor Inspection
Installation Visual Inspection 1. Inspect for the following: If there is any malfunction, replace the part. a. Excessive looseness or play of the rear ABS wheel-speed sensor b. Deformation of the rear ABS wheel-speed sensor c. Deformation or damage of the rear ABS sensor rotor C ...

� 2016-2026 Copyright www.mazda3tech.com