Mazda 3 manuals

Mazda 3 Service Manual: Exhaust & Emissions

Mazda 3 Service Manual / Engine / Exhaust & Emissions

Valve Clearance Inspection [Mzr 2.0, Mzr 2.5]
1. Remove the battery cover.. 2. Disconnect the negative battery cable.. 3. Remove the plug hole plate.. 4. Disconnect the wiring harness. 5. Remove the ignition coils.. 6. Remove the spark ...

Exhaust System Inspection [Mzr 2.0, Mzr 2.5]
1. Start the engine and inspect each exhaust system component for exhaust gas leakage. If there is leakage, repair or replace the appropriate component.. ...

Other materials:

Oil Seal (Differential) Replacement [C66 M R]
1. Remove the aerodynamic under cover No.2 and the splash shield as a single unit.. 2. Drain the manual transaxle oil.. 3. Disconnect the drive shaft (LH) from the MTX.. 4. Disconnect the drive shaft (RH) from the joint shaft.. 5. Remove the joint shaft.. 6. Remove the oil seal (LH). ...

Heated Oxygen Sensor (HO2 S) Inspection [Mzr 2.0, Mzr 2.5]
HO2S Inspection 1. Connect the M-MDS to the DLC-2. 2. Switch the ignition to ON. 3. Warm up the engine to normal operating temperature. 4. Access the following PIDs using the M-MDS.. VSS (Vehicle speed) RPM (Engine speed) O2S12 (HO2S output voltage) 5. Drive ...

Front Seat Rail Guide Cover Removal/Installation
WARNING: Handling a front seat (with built-in side air bag) improperly can accidentally operate (deploy) the air bag, which may seriously injure you. Read the service warnings before handling a front seat (with built-in side air bag).. CAUTION: After removing a front seat ...

� 2016-2026 Copyright www.mazda3tech.com