Mazda 3 Service Manual: M Position Switch Inspection [FS5 A EL]

Mazda 3 Service Manual / Drivetrain / Transmission/Transaxle / Automatic / M Position Switch Inspection [FS5 A EL]

1. Perform the following procedures.

a. Remove the battery cover..

b. Disconnect the negative battery cable.

c. Remove the console..

d. Disconnect the selector lever component connector.

2. Inspect the continuity between the selector lever component terminals A and H.

If there is any malfunction, replace the selector lever component..

M position switch specification


Test condition	Continuity
M position	Continuity
Except M position	No continuity

Key Interlock System Inspection

Key Interlock System Inspection 1. Switch the ignition to ON. 2. Perform the following procedures to inspect the key interlock system. If there is any malfunction, inspect the key interlock ...

M Position Switch Inspection [Fw6 A EL]

Continuity Inspection NOTE: The M position switch is built into the selector lever component. 1. Remove the battery cover.. 2. Disconnect the negative battery cable.. 3. Remove the ...

Other materials:

Basic Inspection [FS5 A EL]
STEP INSPECTION ACTION 1 Measure the battery voltage. Is the battery voltage 10.0—14.0 V? Yes Go to the next step. No Replace or recharge the battery. (See BATTERY RECHA ...

Passenger Side Air Bag Module Removal/Installation [Two Step Deployment Control System]
WARNING: Handling the air bag module improperly can accidentally deploy the air bag module, which may seriously injure you. Read the air bag system service warnings and cautions before handling the air bag module.. Due to the adoption of 2-step deployment control in the passeng ...

Driving Tips
WARNING Do not let the vehicle move in a direction opposite to the direction selected by the selector lever: Do not let the vehicle move backward with the selector lever in a forward position, or do not let the vehicle move forward with the selector lever in the revers ...