Mazda 3 manuals

Mazda 3 Service Manual: Power Window Main Switch Removal/Installation

Mazda 3 Service Manual / Body / Glass & Windows / Power Window Main Switch Removal/Installation

1. Disconnect the negative battery cable..

2. Remove the inner garnish. (driver's side).

3. Remove the front door trim. (driver's side).

4. Remove the power window main switch..

5. Install in the reverse order of removal.

Power Window Main Switch Inspection
1. Disconnect the negative battery cable. 2. Remove the inner garnish. (driver's side). 3. Remove the front door trim. (driver's side). 4. Remove the main switch panel. (driver's sid ...

Power Window Motor Inspection
Front Driver Side 1. Disconnect the negative battery cable.. 2. Remove the inner garnish.. 3. Remove the front door trim.. 4. Disconnect the power window motor connector. 5. Apply battery pos ...

Other materials:

Base Removal
1. Remove the rearview mirror.. 2. Wind each end of a wire around a bar. WARNING: Using the piano wire with bare hands can cause injury. Always wear gloves when using the piano wire. NOTE: Use a long sawing action to spread the work over the whole length of the pi ...

Variable Swirl Solenoid Valve Inspection [Mzr 2.3 Disi Turbo]
Airflow Inspection 1. Remove the battery cover.. 2. Disconnect the negative battery cable.. 3. Remove the variable swirl solenoid valve.. 4. Inspect the airflow between the ports under the following conditions. If not as specified, replace the variable swirl solenoid valve.. ...

Clutch Unit Removal/Installation [C66 M R]
1. Remove the battery cover.. 2. Disconnect the negative battery cable.. 3. Remove the aerodynamic under cover No.2 and the splash shield as a single unit.. 4. Drain the manual transaxle oil.. 5. Disconnect and/or remove the following parts in the engine compartment. a. Remove the batte ...

� 2016-2026 Copyright www.mazda3tech.com