Mazda 3 Service Manual: Rear Shock Absorber Removal/Installation

Rear Shock Absorber Inspection

1. Remove the rear shock absorber.. 2. Inspect for damage and oil leakage. 3. Compress and extend the shock piston at least three times. Verify that the operational force does not change and tha ...

Rear Stabilizer Control Link Inspection

1. Remove the rear stabilizer control link from the vehicle.. 2. Inspect for bending or damage. If there is any malfunction, replace the rear stabilizer control link. 3. Rotate the ball joint st ...

Other materials:

Keyless Control Module Inspection
1. Remove the following parts: a. Passenger-side front scuff plate. b. Passenger-side front side trim. c. Grove compartment. d. Passenger-side lower panel. 2. Measure the voltage according to the terminal voltage table. If the voltages cannot be verified as indicated in the termina ...

Automatic Transaxle Fluid (ATF) Inspection [Fw6 A EL]
CAUTION: If the ATF level is not within the specification or ATF is not adhering to the dipstick after warming up the engine, do not drive the vehicle. Otherwise, the transaxle could be damaged. ATF Level Inspection 1. Remove aerodynamic undercover No.2.. 2. Remove the dipstic ...

Outer Mirror Garnish Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the outer mirror glass from the outer mirror.. 3. Pinch the end of the tab which is visible, and release the tab by pressing it toward the vehicle front (3 locations). 4. Grasp the upper side of the outer mirror garnish and remove it b ...