Mazda 3 manuals

Mazda 3 Service Manual: Suspension

No.7 Bsm Indicator Light Does Not Flash While Under Bsm Indicator Light Flashing Conditions (With Combination Switch Operation (Turn Signal Switch)) [Blind Spot Monitoring (Bsm)]
7 BSM indicator light does not flash while under BSM indicator light-flashing conditions (with combination switch operation (turn signal switch)) Desc ...

General Procedures (Suspension)
Wheel and Tire Installation 1. When installing the wheels and tires, tighten the wheel nuts in a criss-cross pattern to the following tightening torque. Tightening torque 88—118 N· ...

Other materials:

Up Switch Inspection [Fw6 A EL]
Continuity Inspection NOTE: The up switch is built into the selector lever component. 1. Remove the battery cover.. 2. Disconnect the negative battery cable.. 3. Remove the console.. 4. Disconnect the selector lever component connector. 5. Verify that the continuity betwee ...

Drive Shaft (Double Offset Joint) Disassembly/Assembly
1. Disassemble in the order indicated in the table. 2. Assemble in the reverse order of disassembly. 1 Boot band (transaxle side) (See DRIVE SHAFT (TRIPOD JOINT) DISASSEMBLY/ASSEMBLY.) 2 Outer ring (See Outer Ring, Clip Assembly Note. ...

Evaporator Temperature Sensor Inspection [Manual Air Conditioner]
NOTE: Inspect the evaporator temperature sensor when it is installed to the A/C unit. 1. Set the fan speed MAX HI. 2. Set the temperature control at MAX COLD. 3. Set the RECIRCULATE mode. 4. Turn the A/C switch off. 5. Close all doors and windows. 6. Wait for 5 min. 7. D ...

� 2016-2026 Copyright www.mazda3tech.com