Mazda 3 manuals

Mazda 3 Service Manual: Rear Suspension

Mazda 3 Service Manual / Suspension / Rear Suspension

Wheel Hub, Steering Knuckle Removal/Installation
CAUTION: Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the wiring harness if it is pulled by mistake. Before ...

Rear Coil Spring Removal/Installation
1. Disconnect the auto leveling sensor lower side. (Vehicles with AFS). 2. Remove in the order indicated in the table. 3. Install in the reverse order of removal. 4. Inspect the wheel alignment ...

Other materials:

Automatic Transaxle Removal/Installation [FS5 A EL]
CAUTION: Secure the steering wheel using tape or a cable to prevent the steering shaft from rotating after disconnecting the steering shaft. If the steering wheel rotates after the steering shaft and the steering gear and linkage are disconnected, the internal parts of the clock spr ...

Ignition Switch
Push Button Start Positions The system operates only when the key is within operational range. Each time the push button start is pressed, the ignition switches in the order of off, ACC, and ON. Pressing the push button start again from ON switches the ignition off. NOTE The engine ...

Bluetooth® Audio (Type A)
Applicable Bluetooth ® specification (Recommended) Ver. 2.0 Response profile A2DP (Advanced Audio Distribution Profile) Ver. 1.0/1.2 AVRCP (Audio/Video Remote Control Profile) Ver. 1.0/1.3 A2DP is a profile which transmits only audio to the Bluetooth ® unit. If your Bluetooth ® ...

� 2016-2026 Copyright www.mazda3tech.com