Mazda 3 manuals

Mazda 3 Service Manual: Rear Wiper Motor Removal/Installation

Mazda 3 Service Manual / Body / Wipers, Washers / Wipers / Rear Wiper Motor Removal/Installation

1. Disconnect the negative battery cable..

2. Remove the following parts:

a. Rear wiper arm and blade.

b. Liftgate upper trim.

c. Liftgate side trim.

d. Liftgate lower trim.

3. Disconnect the rear wiper motor connector.


4. Remove the bolts, then remove the rear wiper motor.

5. Remove the outer bushing.

6. Install in the reverse order of removal.

Rear Wiper Motor Inspection
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Rear wiper arm and blade. b. Liftgate upper trim. c. Liftgate side trim. d. Liftgate lower trim. 3. Disconnect ...

Windshield Wiper Arm And Blade Adjustment
1. Operate the windshield wipers, and then turn off the windshield wiper motor to set the wipers in the auto stop position. 2. Slide the serrated connecting part and adjust the windshield wiper ar ...

Other materials:

Transmission/Transaxle SST
1: Mazda SST number 2: Global SST number Example 1:49 UN30 3009 2:303-009 Crankshaft damper remover Clutch [G35M-R] 1:49 E011 1A0 2: – Ring gear brake set 1:49 SE01 310A 2: – Clutch disc center ...

Manual Transaxle Removal/Installation [A26 M R]
CAUTION: Secure the steering wheel using tape or a cable to prevent the steering shaft from rotating after disconnecting the steering shaft. If the steering wheel rotates after the steering shaft and the steering gear and linkage are disconnected, the internal parts of the clock spr ...

Oil Pump Removal/Installation [Mzr 2.0, Mzr 2.5]
WARNING: Hot engines and engine oil can cause severe burns. Turn off the engine and wait until it and the engine oil have cooled. A vehicle that is lifted but not securely supported on safety stands is dangerous. It can slip or fall, causing death or serious injury. Never work ...

� 2016-2026 Copyright www.mazda3tech.com