Mazda 3 manuals

Mazda 3 Service Manual: Wipers

Washer Fluid Level Sensor Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the front bumper.. 3. Remove the washer tank.. 4. Remove the connector of the washer fluid-level sensor from the washer tank. 5. Remov ...

Rear Wiper Arm And Blade Adjustment
1. Turn off the rear wiper switch while operating the rear wiper motor, and then stop the rear wiper at the auto stop position. 2. Set the rear wiper arm onto the ceramic end line. ...

Other materials:

Joint Shaft Removal/Installation [Skyactiv G 2.0]
CAUTION: Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the wiring harness if it is pulled by mistake. Before performing the following procedures, remove the ABS wheel-speed sensor connector (axle side) and ...

Relay Block Inspection [With Advanced Keyless Entry And Push Button Start System]
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Driver-side front scuff plate. b. Driver-side front side trim. c. Hood release lever. d. Upper panel. e. Shift knob (MTX)(See MANUAL TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION [G66M-R].)(See MANUAL TRANSAX ...

Oil Control Valve (OCV) Inspection [Mzr 2.3 Disi Turbo]
Coil Resistance Inspection 1. Remove the battery cover.. 2. Disconnect the negative battery cable.. 3. Disconnect the OCV connector. 4. Measure the coil resistance between terminals A and B using a tester. If not as specified, replace the OCV.. OCV coil resistance 6. ...

� 2016-2026 Copyright www.mazda3tech.com