Mazda 3 manuals

Mazda 3 Service Manual: Seat Weight Sensor Removal/Installation [Two Step Deployment Control System]

Mazda 3 Service Manual / Engine / Control / Information / Seat Weight Sensor Removal/Installation [Two Step Deployment Control System]

CAUTION:

Seat Weight Sensor Inspection [Two Step Deployment Control System]
CAUTION: If any of the following work is performed, perform the seat weight sensor inspection using the M-MDS. Removal of the passenger-side seat Loosening and retig ...

Side Air Bag Sensor No. 1 Removal/Installation [Two Step Deployment Control System]
WARNING: Handling the side air bag sensor improperly can accidentally operate (deploy) the air bag module, which may seriously injure you. Read the air bag system service warnings and ca ...

Other materials:

Front Beltline Molding Removal/Installation
1. Fully open the front door glass. 2. Disconnect the negative battery cable.. 3. Remove the inner garnish.. 4. Remove the front door trim.. 5. Remove the power outer mirror.. 6. Remove clip A using a fastener remover and pull the front beltline molding in the direction of the arrow (1) ...

Drive Shaft (Double Offset Joint) Disassembly/Assembly
1. Disassemble in the order indicated in the table. 2. Assemble in the reverse order of disassembly. 1 Boot band (transaxle side) (See DRIVE SHAFT (TRIPOD JOINT) DISASSEMBLY/ASSEMBLY.) 2 Outer ring (See Outer Ring, Clip Assembly Note. ...

Rear Door Trim Disassembly/Assembly
1. Disassemble in the order shown in the figure. 1 Screw 2 Assist handle 3 Switch panel cover 4 Power window subswitch 5 Rear door trim 2. Assembl ...

� 2016-2026 Copyright www.mazda3tech.com