Mazda 3 manuals

Mazda 3 Service Manual: Sensors, Switches, Relays

Mazda 3 Service Manual / Body / Lighting & Horn / Sensors, Switches, Relays

Vanity Mirror Illumination Inspection
1. Disconnect the negative battery cable.. 2. Remove the sunvisor.. 3. Verify that the continuity between the vanity mirror illumination terminals is as indicated in the table. If no ...

Light Switch Inspection
Vehicles Without Auto Light System 1. Disconnect the negative battery cable.. 2. Remove the column cover.. 3. Remove the light switch.. 4. Verify that the continuity between the light switch te ...

Other materials:

Front ABS Wheel Speed Sensor Inspection
Sensor Output Value Inspection CAUTION: Resistance inspection using other testers may cause damage to the ABS wheel-speed sensor internal circuit. Be sure to use the M-MDS to inspect the ABS wheel-speed sensor. 1. Switch the ignition to off. 2. Connect the M-MDS to the DLC-2. ...

Rear Wiper Motor Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Rear wiper arm and blade. b. Liftgate upper trim. c. Liftgate side trim. d. Liftgate lower trim. 3. Disconnect the rear wiper motor connector. 4. Remove the bolts, then remove the rear wiper motor. 5. Re ...

Front passenger occupant classification system
The Subaru Solterra is equipped with an advanced front passenger occupant classification system that continuously monitors the status of the front passenger seat. Based on detected conditions, this intelligent system automatically activates or deactivates specific SRS airbags to optimize safet ...

� 2016-2026 Copyright www.mazda3tech.com