Mazda 3 manuals

Mazda 3 Service Manual: Starter Interlock Switch Inspection [Skyactiv G 2.0]

Mazda 3 Service Manual / Drivetrain / Transmission/Transaxle / Automatic / Starter Interlock Switch Inspection [Skyactiv G 2.0]

CAUTION:

  1. Do not reuse the starter interlock switch if it is removed from the vehicle even once. Replace with a new starter interlock switch when installing.

1. Remove the battery cover..

2. Disconnect the negative battery cable..

3. Disconnect the starter interlock switch connector.

4. Verify that the continuity is as indicated in the table using a tester.



Starter Interlock Switch Inspection [Mzr 2.3 Disi Turbo]
CAUTION: Do not reuse the starter interlock switch if it is removed from the vehicle even once. Replace with a new starter interlock switch when installing. 1. Remove the battery cove ...

Starter Interlock Switch Removal/Installation [C66 M R]
1. Remove the battery cover.. 2. Disconnect the negative battery cable.. 3. Disconnect the starter interlock switch connector. 4. Remove the starter interlock switch from the pedal bracket. ...

Other materials:

Operating the Satellite Radio
What is satellite radio? With over 130 channels, SiriusXM Satellite Radio brings you more of what you love. Get channels and channels of commercial-free music, plus sports, news, talk, entertainment and more. Commercial-free music from nearly every genre — rock to pop, hip-hop to country ...

Fuel Pump Control Module Inspection [Skyactiv G 2.0]
1. Perform the KOEO self-test.. 2. Verify that a fuel pump control module related DTC is detected.. If DTCs are detected, repair the malfunctioning part according to the applicable DTC troubleshooting.. If a DTC is not detected, go to the next step. 3. Inspect the followin ...

Oil Seal (Differential) Replacement [C66 M R]
1. Remove the aerodynamic under cover No.2 and the splash shield as a single unit.. 2. Drain the manual transaxle oil.. 3. Disconnect the drive shaft (LH) from the MTX.. 4. Disconnect the drive shaft (RH) from the joint shaft.. 5. Remove the joint shaft.. 6. Remove the oil seal (LH). ...

� 2016-2026 Copyright www.mazda3tech.com