Mazda 3 Service Manual: Transaxle Oil Inspection [G66 M R]

Mazda 3 Service Manual / Drivetrain / Transmission/Transaxle / Information / Transaxle Oil Inspection [G66 M R]

1. Park the vehicle on level ground.

2. Remove the aerodynamic under cover No.2..

3. Remove the oil level plug and washer.

4. Verify that the oil is near the brim of the plug port.

If the oil level is lower than the low level, add the specified amount and type of oil through the oil level plug hole.

Manual transaxle oil


Item	Specification
Grade	API service GL-4
Viscosity	SAE 75W-80

5. Install a new washer and the oil level plug.

Tightening torque

39—59 N·m {4.0—6.0 kgf·m, 29—43 ft·lbf}

6. Install the aerodynamic under cover No.2..

Transaxle Oil Inspection [G35 M R]

1. Park the vehicle on level ground. 2. Remove the aerodynamic under cover No.2.. 3. Remove the oil level plug and washer. 4. Verify that the oil is near the brim of the plug port. I ...

Transaxle Oil Replacement [A26 M R]

1. Park the vehicle on level ground. 2. Remove the aerodynamic under cover No.2.. 3. Remove the drain plug and gasket. 4. Drain the oil into a suitable container. 5. Install a new gasket a ...

Other materials:

If a Warning Light Turns On or Flashes
If any warning light turns on/flashes, take appropriate action for each light. There is no problem if the light turns off, however if the light does not turn off or turns on/flashes again, consult an Authorized Mazda Dealer. (Vehicles with type B audio) The warning contents can be verified o ...

Manual Transaxle Removal/Installation [A26 M R]
CAUTION: Secure the steering wheel using tape or a cable to prevent the steering shaft from rotating after disconnecting the steering shaft. If the steering wheel rotates after the steering shaft and the steering gear and linkage are disconnected, the internal parts of the clock spr ...

Boost Air Temperature Sensor Inspection [Mzr 2.3 Disi Turbo]
Resistance Inspection NOTE: Because the boost air temperature sensor is integrated in the MAP sensor, replacing the boost air temperature sensor includes replacement of the MAP sensor/boost air temperature sensor. 1. Remove the battery cover.. 2. Disconnect the negative batter ...