Mazda 3 Service Manual: Transaxle Oil Replacement [G35 M R]

Mazda 3 Service Manual / Drivetrain / Transmission/Transaxle / Information / Transaxle Oil Replacement [G35 M R]

1. Park the vehicle on level ground.

2. Remove the aerodynamic under cover No.2..

3. Remove the drain plug and washer.

4. Drain the oil into a suitable container.

5. Install a new washer and the drain plug.

Tightening torque

39—59 N·m {4.0—6.0 kgf·m, 29—43 ft·lbf}

6. Remove the oil level plug and washer.

7. Add the specified amount and type of oil through the oil level plug hole until the level reaches the bottom of the oil level plug hole. Manual transaxle oil


Item	Specification
Grade	API service GL-4
Viscosity	SAE 75W-80
Capacity (approx. quantity)	2.77 L {2.93 US qt, 2.44 lmp qt}

8. Install a new washer and the oil level plug.

Tightening torque

39—59 N·m {4.0—6.0 kgf·m, 29—43 ft·lbf}

9. Install the aerodynamic under cover No.2..

Transaxle Oil Replacement [A26 M R]

1. Park the vehicle on level ground. 2. Remove the aerodynamic under cover No.2.. 3. Remove the drain plug and gasket. 4. Drain the oil into a suitable container. 5. Install a new gasket a ...

Transaxle Oil Replacement [G66 M R]

1. Park the vehicle on level ground. 2. Remove the aerodynamic under cover No.2.. 3. Remove the drain plug and washer. 4. Drain the oil into a suitable container. 5. Install a new washer a ...

Other materials:

Engine Coolant Leakage Inspection [Mzr 2.0, Mzr 2.5]
WARNING: Never remove the cooling system cap or loosen the radiator drain plug while the engine is running, or when the engine and radiator are hot. Scalding engine coolant and steam may shoot out and cause serious injury. It may also damage the engine and cooling system. Tu ...

High Mount Brake Light Removal/Installation
4SD 1. Disconnect the negative battery cable.. 2. Remove the trunk lid trim.. 3. Disconnect the connector. 4. Remove the nuts. 5. While pressing the tabs shown in the figure, pull the high-mount brake light outward and remove it. 6. Remove the high-mount brake light. 7. Instal ...

Basic Inspection [FS5 A EL]
STEP INSPECTION ACTION 1 Measure the battery voltage. Is the battery voltage 10.0—14.0 V? Yes Go to the next step. No Replace or recharge the battery. (See BATTERY RECHA ...