Mazda 3 manuals

Mazda 3 Service Manual: Vehicle Speed Sensor (VSS) Removal/Installation [FS5 A EL]

Mazda 3 Service Manual / Drivetrain / Sensors, Switches, Relays / Vehicle Speed Sensor (VSS) Removal/Installation [FS5 A EL]

CAUTION:

1. Perform the following procedures.

a. Remove the battery cover..

b. Disconnect the negative battery cable.

c. Remove the insulator from the transaxle.


2. Remove in the order indicated in the table.



1

Connector

2

VSS

3

O-ring


3. Install in the reverse order of removal.

Vehicle Speed Sensor (VSS) Inspection [FS5 A EL]
On-Vehicle Inspection 1. Inspect the power supply circuit for the VSS. a. Remove the insulator from the transaxle. b. Disconnect the VSS connector. c. Switch the ignition to ON (engine ...

Transmission/Transaxle
...

Other materials:

Glass Panel Adjustment
1. Fully close the glass panel. 2. Measure the gap and height between the glass panel and body. If not as specified, loosen the glass panel installation screws and reposition the glass panel. Clearance (4SD) a: -2.4—0.2 mm {-0.09—0.01 in} b: 0 mm {0 in} ...

Ignition Switch Removal/Installation [Without Advanced Keyless Entry And Push Button Start System]
1. Disconnect the negative battery cable.. 2. Remove the column cover.. 3. Detach the tab. 4. Pull the pin in the direction of the arrow shown in the figure and release the lock. 5. Disconnect the ignition switch connector and key interlock solenoid connector. 6. Remove the ...

AHB (Automatic High Beam)
The Automatic High Beam system in the Subaru Solterra utilizes a forward-facing camera mounted near the upper windshield area to continuously monitor surrounding light conditions. By analyzing headlights of oncoming vehicles, taillights ahead, street lighting, and ambient brightness, the Subar ...

� 2016-2026 Copyright www.mazda3tech.com