Mazda 3 manuals

Mazda 3 Owners Manual: Daytime Running Lights

Some countries require moving vehicles to have their lights on (daytime running lights) during the daytime.

Daytime running lights turn on automatically when the ignition is switched ON.

They turn off when the parking brake is operated or the shift lever is shifted to the P position (automatic transaxle vehicle).

NOTE (Except Canada) The daytime running lights can be deactivated.

Refer to Personalization Features on .

Headlight Leveling
The number of passengers and weight of cargo in the luggage compartment change the angle of the headlights. Auto type The angle of the headlights will be automatically adjusted when turning on t ...

Fog Lights
Use this switch to turn on the fog lights. The fog lights will improve visibility at night and during foggy conditions. To turn the fog lights on, rotate the fog light switch to the position. ...

Other materials:

Inner Garnish Removal/Installation
1. Disconnect the negative battery cable.. 2. Pull the inner garnish in the direction of the arrow shown in the figure and remove it while detaching clips and tab. CAUTION: When pulling out the inner garnish, be careful not to damage the tab. 3. Disconnect the front tweeter c ...

Control Valve Body Removal/Installation [Fw6 A EL]
On-Vehicle Removal WARNING: A hot transaxle and ATF can cause severe burns. Turn off the engine and wait until they are cool. Using compressed air can cause dirt and other particles to fly out, causing injury to the eyes. Wear protective eyeglasses whenever using compressed ai ...

Ignition Coil Removal/Installation [Mzr 2.0, Mzr 2.5]
1. Remove the battery cover.. 2. Disconnect the negative battery cable.. 3. Remove the plug hole plate.. 4. Remove in the order indicated in the table. 5. Install in the reverse order of removal. 1 Plug hole plate bracket 2 Connector ...

� 2016-2026 Copyright www.mazda3tech.com