Mazda 3 Service Manual: Air Cleaner Element Inspection [Mzr 2.0, Mzr 2.5]
1. Remove the air cleaner element..
2. Inspect the following items:
-
Has the replacement interval come?
-
Is the air cleaner element soiled, damaged, or bent?
-
Are the air cleaner case and the air cleaner element correctly sealed?
-
Is the correct air cleaner element installed?
-
If there is any abnormality, clean or replace the air cleaner element..
Intake
...
Air Cleaner Element Removal/Installation [Mzr 2.0, Mzr 2.5]
1. Set the air cleaner cover out of the way..
2. Remove the air cleaner element.
3. Install in the reverse order of removal. ...
Other materials:
Pilot Bearing Inspection [A26 M R]
CAUTION:
Secure the steering wheel using tape or a cable to prevent the steering shaft
from rotating after disconnecting the steering shaft. If the steering wheel
rotates after the steering shaft and the steering gear and linkage are disconnected,
the internal parts of the clock spr ...
Rear Crossmember Removal/Installation
CAUTION:
Performing the following procedures without first removing the ABS wheel-speed
sensor may possibly cause an open circuit in the wiring harness if it is pulled
by mistake. Before performing the following procedures, disconnect the ABS wheel-speed
sensor wiring harness connec ...
A/C Compressor Removal/Installation
1. Disconnect the negative battery cable..
2. Discharge the refrigerant..
3. Remove the aerodynamic under cover No.2..
4. Remove the drive belt..
5. Remove the water hose bracket.
CAUTION:
If moisture or foreign material enters the refrigeration cycle, cooling ability
will b ...
