Mazda 3 manuals

Mazda 3 Service Manual: Data Network

Ignition Switch Removal/Installation [Without Advanced Keyless Entry And Push Button Start System]
1. Disconnect the negative battery cable.. 2. Remove the column cover.. 3. Detach the tab. 4. Pull the pin in the direction of the arrow shown in the figure and release the lock. 5. ...

Body Control Module (Bcm) Configuration
1. Connect the M-MDS to DLC-2. 2. After the vehicle is identified, select the following items from the initial screen of the M-MDS. When using the IDS (laptop PC) Select â ...

Other materials:

Variable Valve Timing Actuator Removal/Installation [Mzr 2.3 Disi Turbo]
WARNING: Fuel vapor is hazardous. It can very easily ignite, causing serious injury and damage. Always keep sparks and flames away from fuel. Fuel line spills and leakage are dangerous. Fuel can ignite and cause serious injuries or death and damage. Fuel can also irritate skin ...

Rear Lower Arm Removal/Installation
1. Disconnect the auto leveling sensor link lower side. (Vehicles with AFS). 2. Remove in the order indicated in the table. 3. Install in the reverse order of removal. 4. Inspect the wheel alignment and adjust it if necessary.. 1 Rear coil spring component . ...

Solenoid Valve Inspection [FS5 A EL]
CAUTION: Water or foreign objects entering the connector can cause a poor connection or corrosion. Be sure not to drop water or foreign objects on the connector when disconnecting it. Primary Control Valve Body On-vehicle inspection 1. Perform the following procedures. a. Rem ...

� 2016-2026 Copyright www.mazda3tech.com