Mazda 3 manuals

Mazda 3 Service Manual: Inspection After Transaxle Installation [A26 M R]

Mazda 3 Service Manual / Drivetrain / Transmission/Transaxle / Information / Inspection After Transaxle Installation [A26 M R]

NOTE:

1. Perform a road test and inspect the following items:

a. No abnormal noise in each shift position.

b. Smooth shift operation when shifting gears.

c. No gear slipout after shifting gears.

d. Back-up light switch operates correctly.

Information
...

Inspection After Transaxle Installation [G35 M R]
NOTE: Perform the following inspection only when the transaxle has been overhauled. 1. Perform a road test and inspect the following items: a. No abnormal noise in each shift position. ...

Other materials:

Air Filter Removal/Installation [Skyactiv G 2.0]
1. Remove the fuel-filler pipe protector.. 2. Remove in the order indicated in the table. 1 Evaporative hose 2 Air filter 3. Install in the reverse order of removal. ...

Tire House Trim Removal/Installation
4SD 1. Remove the rear seat cushion.. 2. Remove the rear scuff plate.. 3. Partially peel back the seaming welt. 4. Remove the fastener. 5. Pull the tire house trim in the direction of arrow shown in the figure while remove the clip A, pin B and C. 6. Pull the tire house trim in the ...

Clutch Pedal Inspection [C66 M R]
NOTE: For the clutch pedal inspection, note the followings and measure each inspection location. Measure the center of the upper surface of the pedal pad for each inspection. If the distance from the pedal pad to the floor covering is measured, measure the shor ...

� 2016-2026 Copyright www.mazda3tech.com