Mazda 3 manuals

Mazda 3 Service Manual: Inspection After Transaxle Installation [G35 M R]

Mazda 3 Service Manual / Drivetrain / Transmission/Transaxle / Information / Inspection After Transaxle Installation [G35 M R]

NOTE:

1. Perform a road test and inspect the following items:

a. No abnormal noise in each shift position.

b. Smooth shift operation when shifting gears.

c. No gear slipout after shifting gears.

d. Back-up light switch operates correctly.

Inspection After Transaxle Installation [A26 M R]
NOTE: Perform the following inspection only when the transaxle has been overhauled. 1. Perform a road test and inspect the following items: a. No abnormal noise in each shift position. ...

Inspection After Transaxle Installation [G66 M R]
NOTE: Perform the following inspection only when the transaxle has been overhauled. 1. Perform a road test and inspect the following items: a. No abnormal noise in each shift position. ...

Other materials:

Fuel Gauge Sender Unit Inspection
MZR 2.3 DISI Turbo, SKYACTIV-G 2.0 NOTE: The fuel gauge sender unit is integrated with the fuel pump unit. 1. Disconnect the negative battery cable.. 2. Remove the rear seat cushion.. 3. Remove the fuel pump unit.. 4. Verify that the resistance between terminals A and C of the f ...

Air Mix Actuator Inspection [Full Auto Air Conditioner]
CAUTION: If the lever position exceeds the operation range shown in the figure, the circuit in the actuator could be damaged. Always perform an actuator operation inspection with the lever movement within the range shown in the figure. Driver-side 1. Connect battery positive vol ...

Center Roof Antenna Inspection
4SD 1. Disconnect the negative battery cable.. 2. Remove the rain sensor cover. (Vehicles with auto light/wiper system). 3. Disconnect the rain sensor connector. (Vehicles with auto light/wiper system) 4. Partially peel back the seaming welts. 5. Remove the following parts: a. Sunroof se ...

� 2016-2026 Copyright www.mazda3tech.com