Mazda 3 manuals

Mazda 3 Service Manual: Manual transmission

Vehicle Speed Sensor (VSS) Removal/Installation [FS5 A EL]
CAUTION: If foreign materials are stuck to the sensor, disturbance by magnetic flux can cause sensor output to be abnormal and thereby negatively affect control. Make sure that foreign m ...

Inspection After Manual Transaxle Overhaul [C66 M R]
1. After warming up the engine, drive the vehicle and inspect the following items: a. No abnormal noise in each shift position. b. Smooth shift operation when shifting gears. c. No gear slipout ...

Other materials:

Drive Belt Inspection [Skyactiv G 2.0]
Generator Drive Belt NOTE: The generator drive belt deflection/tension inspection is not necessary with the adoption of the drive belt auto tensioner. 1. Verify that the indicator part of the cast hexagon on the drive belt auto tensioner is within the normal range. If ...

Oil Seal (Differential) Replacement [C66 M R]
1. Remove the aerodynamic under cover No.2 and the splash shield as a single unit.. 2. Drain the manual transaxle oil.. 3. Disconnect the drive shaft (LH) from the MTX.. 4. Disconnect the drive shaft (RH) from the joint shaft.. 5. Remove the joint shaft.. 6. Remove the oil seal (LH). ...

Operating the Driver's Power Window
Normal opening/closing To open the window to the desired position, lightly hold down the switch. To close the window to the desired position, lightly pull up the switch. Auto-opening/closing To fully open the window automatically, press the switch completely down, then release. The win ...

� 2016-2026 Copyright www.mazda3tech.com