Mazda 3 manuals

Mazda 3 Service Manual: Parking Brake

Mazda 3 Service Manual / Brakes / Parking Brake

Rear Brake (Disc) Removal/Installation
CAUTION: If the brake hose is installed to the caliper on the vehicle, the tool cannot be installed correctly resulting in brake fluid leakage due to improper installation. Therefore, re ...

Parking Brake Cable Removal/Installation
1. Remove the following parts: a. Upper panel. b. Shift knob (MTX). c. Selector lever knob (ATX). d. Shift panel. e. Side wall. f. Console. 2. Remove the under cover.. 3. Remove the tu ...

Other materials:

Basic Inspection [FS5 A EL]
STEP INSPECTION ACTION 1 Measure the battery voltage. Is the battery voltage 10.0—14.0 V? Yes Go to the next step. No Replace or recharge the battery. (See BATTERY RECHA ...

No.7 Bsm Indicator Light Does Not Flash While Under Bsm Indicator Light Flashing Conditions (With Combination Switch Operation (Turn Signal Switch)) [Blind Spot Monitoring (Bsm)]
7 BSM indicator light does not flash while under BSM indicator light-flashing conditions (with combination switch operation (turn signal switch)) Description The BSM indicator light does not flash or illuminate continuously, ...

Liftgate Upper Trim Removal/Installation
1. Detach tab while pulling the liftgate upper trim in the direction of the arrow (1) shown in the figure, then detach clips and pin while pulling in the direction of the arrow (2). 2. Detach tab while pulling the liftgate upper trim in the direction of the arrow (3) shown in the figure, ...

� 2016-2026 Copyright www.mazda3tech.com