Mazda 3 manuals

Mazda 3 Service Manual: Pilot Bearing Inspection [C66 M R]

Mazda 3 Service Manual / Drivetrain / Transmission/Transaxle / Automatic / Pilot Bearing Inspection [C66 M R]

1. Without removing the pilot bearing, turn the bearing while applying force in the axial direction.


Pilot Bearing Inspection [A26 M R]
CAUTION: Secure the steering wheel using tape or a cable to prevent the steering shaft from rotating after disconnecting the steering shaft. If the steering wheel rotates after the steer ...

Pilot Bearing Inspection [G35 M R]
1. Perform the following procedures. a. Remove the battery cover.. b. Disconnect the negative battery cable. c. Remove the battery component. (ex: battery, battery tray and PCM component). d. ...

Other materials:

Rear Crossmember Removal/Installation
CAUTION: Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the wiring harness if it is pulled by mistake. Before performing the following procedures, disconnect the ABS wheel-speed sensor wiring harness connec ...

Rear Cross Traffic Alert (RCTA)
The Rear Cross Traffic Alert (RCTA) system is designed to assist the driver in checking the area to the rear of the vehicle on both sides while the vehicle is reversing by alerting the driver to the presence of vehicles approaching the rear of the vehicle. The Rear Cross Traffic Alert (RCTA ...

No.6 Bsm Indicator Light Flashes While Not Under Bsm Indicator Light Flashing Conditions (No Combination Switch Operation (Turn Signal Switch)) [Blind Spot Monitoring (Bsm)]
6 BSM indicator light flashes while not under BSM indicator light-flashing conditions (no combination switch operation (turn signal switch) Description The BSM indicator light flashes despite not satisfying the BSM indicator l ...

� 2016-2026 Copyright www.mazda3tech.com