Mazda 3 manuals

Tesla Model 3 2017-2022 Owner's Manual: Attaching Upper Tether Straps

If an upper tether strap is provided, attach its hook to the anchor point located on the shelf behind the rear seats.

Note: The location of anchor points may not be readily visible but can be found by identifying a slice in the seat's material.

Warning: Tighten upper tether straps according to the instructions provided by the manufacturer of the child safety seat.

Warning: USE ONLY SEAT BELT RETAINED CHILD SAFETY SEATS IN THE CENTER SEATING POSITION.

Attaching Upper Tether Straps


To access an anchor point, press down on the back of its cover.

Attaching Upper Tether Straps


For dual-strap tethers, position a strap on each side of the head support.

Attaching Upper Tether Straps


For single-strap tethers at the outboard seating positions, run the strap over the outside-facing side of the head support (same side of the head support as the seat belt retraction mechanism).

Attaching Upper Tether Straps


For a single-strap tether in the center seating position, fully lower the head support and run the strap over the top center of the head support.

Attaching Upper Tether Straps


Testing a Child Safety Seat

Before seating a child, always make sure the child safety seat is not loose:

  1. Hold the child safety seat by the belt path and try to slide the safety seat from side to side and front to back.
  2. If the seat moves more than one inch (2.5 cm), it is too loose. Tighten the belt or reconnect the LATCH retained child safety seat.
  3. If you are unable to reduce slack, try a different seat location or try another child safety seat.
Installing Seat Belt Retained Child Seats
First, make sure that the child safety seat is appropriate for the weight, height, and age of the child. Avoid dressing the child in bulky clothing and do not place any objects between the child ...

Child Safety Seat Warnings
Warning: Extreme hazard! Do not seat a child on the front passenger seat even if you are using a child safety seat. This seat has an airbag in front of it. Although this airbag is disabled when Mo ...

Other materials:

Input/Turbine Speed Sensor Removal/Installation [FS5 A EL]
CAUTION: Always use a new bolt. If the removed input/turbine speed sensor installation bolt is reused, it may cause oil leakage. A sealant coating is applied to the input/turbine speed sensor installation bolt to prevent oil leakage from the installation bolt hole which passes ...

High Mount Brake Light Bulb Removal/Installation
4SD 1. Disconnect the negative battery cable.. 2. Remove the trunk lid trim.. 3. Remove in the order indicated in the table. 1 Connector 2 Socket 3 High-mount brake light bulb 4. Install in the rev ...

Rear Tilt Motor Inspection
1. Remove the battery cover.. 2. Disconnect the negative battery cable and wait 1 min or more.. 3. Disconnect the rear tilt motor connector. 4. Apply battery positive voltage to the rear tilt motor terminals and inspect the rear tilt motor operation If not as specified, replace t ...

2016-2022 Copyright www.mazda3tech.com