Mazda 3 manuals

Mazda 3 Service Manual: Disc Brakes

Rear ABS Wheel Speed Sensor Removal/Installation
1. Remove the under cover.. 2. Remove in the order indicated in the table. 3. Install in the reverse order of removal. 1 Connector 2 Bolt ...

Caliper (Front) Disassembly/Assembly [Mzr 2.0, Skyactiv G 2.0, Mzr 2.5]
1. Disassemble in the order indicated in the table. 1 Bleeder cap 2 Bleeder screw 3 Piston (See Piston Disassem ...

Other materials:

Blind Spot Monitoring (Bsm) Control Module Removal/Installation
CAUTION: If the BSM control modules are installed with the left and right modules reversed, a DTC will be displayed and system will enter the fail-safe function. Therefore, confirm that the left/right BSM control modules are installed correctly. 1. Disconnect the negative battery ...

Vacuum Pump Inspection [Skyactiv G 2.0]
1. Pinch open the clamp using pliers and disconnect the vacuum hose from the vacuum pump. 2. Install the vacuum gauge as shown in the figure, then check the vacuum. 3. Warn up the engine. If the pressure is less than the specification, inspect for the following. M ...

Fuel Filler Lid Opener And Lever Removal/Installation
Fuel-filler Lid Opener 4SD 1. Open the fuel-filler lid. 2. Remove the following parts: a. Trunk end trim. b. Trunk side trim (RH). 3. Remove the nut. 4. Remove the lift spring. 5. Pull out the fuel-filler lid opener in the direction of the arrow (1). 6. Disconnect the fue ...

� 2016-2026 Copyright www.mazda3tech.com